Definitely! ODIS (odis-service) 3.0.1 is verified ok to run on Windows XP operating system with VAS 5054A and 5054 plus for VAG group vehicles diagnosis, including VW, Audi, Skoda, Seat from 1996-2013 and Bently and Lamborghini around 2011.
Note: there are lots of FREE versions on webs, but ususally with unknown security and time-limited.
Why to use ODIS 3.0.1?
Here are all ODIS 3.0.1 update info; that is, the reason for you to choose it.
Release 3.0.1
This release contains software bugfixes
Bugfixes
- VCI exchange not documented in diagnostic protocol
- Internal defects
Release 3.0.0
This release is a new base version with new functions. It has to be installed via SingleSetup.
Reboot after installation
!!! Reboot Windows after installation of ODIS Service!
New functions
- ODIS Service SingleSetup does not install Adobe Reader.
- ODIS Service SingleSetup does not install Virtual Keyboard.
- Support of diagnostic interface VAS6154.
- It is possible to flash an old ECU software version.
- Display of ECU flashability in self-diagnosis is improved.
- The contents of the diagnostic protocol are extended.
- Support requests contain hardware and software version of tester PC.
- Order number is used for diagnostic protocol and diagnostic session filenames.
- Improved manual variant identification.
- Display of names of teststeps can be switched off in GFF..
- Stabilization of GFF hotfix mechanism.
- Diagnostic adresses of ECUs are shown with four digts.
- Improvemed access to self-diagnosis functions.
- New hardware configuration manager for VAS5054/VAS5055.
- Disclaimer changed.
- Changes in ODIS Service update process
- Display of TSB tree without DISS coding.
- Support requests may be stored.
- Display of connection type for diagnostic hardware.
- Support of Internet Explorer 11.
Resolved system defects
- Search in Measured Value Tables did not work correctly.
- Increased occurence of error 4009E
- Some immobilizers could not be adapted.
- Missing timestamp when sending support request in diagnostic protocol
Vehicle restrictions
- For brand AUDI, the Flash mode is supported.
- For brand Volkswagen PKW, the Flash mode is restricted. The usage is only allowed if described in technical bulletins.
- Flash mode is not supported for all other brands.
- Only immobilizer components are diagnosable in LT2 vehicles.
Supported vehicle models
This chapter contains the supported vehicle models
Supported AUDI-Models
- All AUDI vehicle models are supported.
Supported Volkswagen-Models
- All Volkswagen vehicle models are supported.
Supported Volkswagen Nutzfahrzeuge-Models
- 2K - Caddy 2004 >
- 7H/7J - Transporter 2004 >
- 2C - Caddy 2011 >
- 7E/7F - Transporter 2010 >
- 2H - Amarok 2010 >
- 2E/2F - Crafter 2006-2015 >
Supported Seat-Models
- All Seat vehicle models are supported.
Supported Skoda-Models
- All Skoda vehicle models are supported.
Supported Bentley-Models
- All Bentley vehicle models are supported.
Supported Lamborghini-Models
- All Lamborghini vehicle models are supported
没有评论:
发表评论